DESCRIPTION

The Lower Subpanels are the panels located at the bottom of the MIP (Mean Instrument Panel). They are mainly used for controlling the lighting of the MIP for both for the DU's as indirect lighting (Background and AFDS Flood).

This Lower Subpanels of FlyEngravity have a built-in EPB backlight-lighting (12V). Here are the leds already built in and have a warm white color.

The backlight illumination of the MIP and Lower Sub-Panels I have attached to the button MAIN PANEL BRIGHT " and this with a multi-switch.
The first position is for the backlighting MIP and the second position is for the backlighting Lower Sub Panels. There is no dimming feature as the backlighting is not blinded and it is indeed beautiful.

.

CONNECTING SUBPANELS

On the achtzijde are terminals ( + and -) to get the wiring to connect. This can be done directly by soldering on these points or you can use connectors.
I opted for the latter as it is easier to use (release), and also better finished.

.

.

.

.

.

.

All the panels I have provided a 2 pin print connector and and draadstekker (that fits on the print connector) with 2 wires (red (+) and black (-)).
The printconnectors, draadstekkers and kableerdraad (0.2 mm2) I met at Tandy).

.

.

.

.

.

.

.
ELECTRONICS FOR DUMMIES

Plus (+) Red

All red wires connect to each other by solder or through the use of a ‘Rapid clip’.

.

.

.

.

.

.

.
If all the red wires are connected to each other will have one red wire from this collection are to be connected to the switch (contact point 9).
Then from the switch (contact point B) a red wire go to the PC power supply (12V – yellow wire).

.

.

.

.

.

.

Minus (-) Black

All the black wires connect to each other by solder or through the use of a ‘Rapid clip’.
If all the black wires are connected to each other will be one black wire from this collection are to be connected to the PC-psu (a black wire).

.

PC POWER SUPPLY

The subpanels to work on 12V and are connected to a PC-power supply 350 W.

For that you can work with, and the PC-power it must function. You can make the power supply turn on but this will probably not work.
The green or grey cable must first be connected with a black cable. Just the green or gray - and a black cable just below the wide plug off and then soldering and insulating with heat shrink tubing. The PC power supply will now have to work.

.

.

.

.

.

.

The connection between the wiring of the panels, and the PC power supply I have done with 2-piece lusterklemmen you off and you can pull/push. The pins fit perfectly in the voedingstekkers.

.

.

.

.

.

.

.


Translated by Yandex.Translate and Global Translator